3D Printed Elf Boot Wall Vase

Overview

3D Printed Elf Boot Wall Vase features a curled elf-boot form with an opening for dried or faux stems. Use it for dried or faux stems unless a separate watertight liner is added.

Materials and finish

Made from PLA plastic using layer-by-layer 3D printing. Fine layer lines and small surface variations are normal. Colour can look slightly different under different lighting or on different screens.

Size and ordering

Available options run from 4 inches (10 cm) to 13 inches (33 cm): 4 inches (10 cm), 5 inches (13 cm), 6 inches (15 cm), 7 inches (18 cm), 8 inches (21 cm), 9 inches (23 cm), 10 inches (25 cm), 11 inches (28 cm), 12 inches (31 cm), 13 inches (33 cm). The selected size refers to the longest exterior dimension unless stated otherwise. Check the complete product and intended placement before ordering.

Installation and care

Mounting hardware is not listed as included. Choose fixings for the wall and expected load. Watertightness is not specified, so use dried or faux stems or a separate liner. Do not fill the PLA vessel directly with water.

What is included

One 3D printed elf-boot wall vase. Mounting hardware, stems, liner and styling props are not included.

Production and delivery

Production normally takes 1–3 business days. Free worldwide standard shipping is included.

FAQ

Is it watertight?

Watertightness is not specified. Do not pour water directly into the PLA vessel.

Can it hold fresh flowers?

Use a separate watertight liner that fits the selected size.

Are mounting fixings included?

Mounting hardware is not listed as included.

How is size measured?

The selected size is the longest exterior dimension, not internal capacity.